Publications: |
66. S. Bera, S. Ghosh Chowdhury, Y. Estrin and I. Manna, Microstructual evolution in nano-Al2O3 dispersed copper base alloy during equal channel angular pressing, Scripta Mater (submitted)
65. Bertalan Joni, Talal Al-Samman, Sandip Ghosh Chowdhury, Gabor Csiszar and Tamas Ungar, Title: Dislocation densities and prevailing slip-system types determined by X-ray line profile analysis in a textured AZ31 magnesium alloy deformed at different temperatures, J. Applied Crystalography (in press).
64. C. Hasse, S Ghosh Chowdhury, L A B Mora, D A Molodov and G Gottstein, On the relation of microstructure and texture evolution in an austenitic Fe-28Mn-0.28C TWIP steel during cold rolling, Metall Mater Trans A (in press)
63. Mousumi Das, Goutam Das, Mainak Ghosh, Matthias Wegner, V. Rajnikant,
S. Ghosh Chowdhury and T.K.Pal, Microstructures and mechanical properties of HPT processed 6063 Al alloy, Mater Sci. Engg A, 558, 2012, 525-532.
62. S. Bera, S. Ghosh Chowdhury, Y. Estrin and I. Manna, Mechanical properties of Al7075 alloy with nano-ceramic oxide dispersion by mechanical alloying and consolidation by equal channel angular pressing, J. Alloys Compounds, 548, 2013, 257-265.
61. S. Bera, S. Ghosh Chowdhury, W. Lojkowsky and I. Manna, Synthesis of CuCr/CuCrAg alloys with extended solid solubility with nano-Al2O3 dispersion by mechanical alloying and consolidation by high pressure sintering, Mater. Sci Engg 558, 2012, 298-308
60. Puspendu Sahu, PhD; S.K. Shee; A.S. Hamada; L. Rovatti; T. Sahu; B. Mahato; S. Ghosh Chowdhury; D.A. Porter; L.P. Karjalainen, Low strain rate deformation behavior of a Cr-Mn austenitic steel at -80°C, Acta Mater 60, 2012, 6907-6919
59. R Singh, S Ghosh Chowdhury, G Das, P K Singh and I Chattoraj, Study on sensitization susceptibility and texture of cold rolled AIS304LN stainless steel, Mater Sci Forum, 702-703, 2012, p677.
58. V. C. Srivastava, T. Singh, S. Ghosh Chowdhury and V. Jindal, Microstructural Characteristics of Accumulative Roll Bonded Ni-Al Based Metal-Intermetallic Laminate Composite. J. Mater. Engg. Perform (in press: DOI: 10.1007/s11665-011-0114-y).
57. X.Li, F.Jiao, T.Al-Samman and S. Ghosh Chowdhury, Influence of second phase precipitates on the texture evolution of Mg-Al-Zn alloys during hot deformation, Scripta Mater, 66, 2012, 159-162.
56. Raghuvir Singh, S. Ghosh Chowdhury, Gautam Das, P.K. Singh and I. Chattoraj, Low temperature sensitization on the orthogonal surfaces of prior deformed AISI 304LN and aged at 400-600oC, Metall. Mater. Trans. A, 43, 2011, 986-1003.
55. Sandip Ghosh Chowdhury, J. Gubicza, B.Mahato, N.Q. Chinh, Z. Hegedus and T.G. Langdon, Texture evolution during room Temperature Ageing of Silver processed by equal Channel Angular Pressing, Scripta Mater 64, 2011, 1007-1010.
54. J. Chakraborty, Kishor Kumar K., Rajeev Ranjan, S.Ghosh Chowdhury and S. R. Singh, Thickness dependent fcc – hcp phase transformation in polycrystalline titanium thin films, Acta Mater 59, 2011, 2615-2623.
53. T. Al-Samman, X. Li and S. Ghosh Chowdhury, Orientation dependent slip and twinning during compression and tension of strongly textured magnesium AZ31 alloy, Mater. Sci. Engg. A A.527, 2010, 3450-3463.
52. J. Chakraborty, Kishor Kumar, R. Ranjan, S.G.Chowdhury and S. R. Singh, Stress, Texture and Phase Transformation in Titanium Thin Films, Solid State Phenomena Vol. 160 (2010) pp 109-116.
51. Puspendu Sahu, Sven Curtze, Arpan Das, B. Mahato, Veli-Tapani Kuokkala, Sandip Ghosh Chowdhury, Stability of austenite and quasi-adiabatic heating during high-strain-rate deformation of twinning-induced plasticity steels, Scripta Mater, 62, 2010, 5-8.
|